Data

Information

Product description
High-quality, very easy-to-process, elasto-plastic sealant
based on acrylic dispersion for sealing joints, seams, cracks and
cracks. Can be painted over and fitted tightly. Can be used indoors and outdoors.
(Acrylic sealant is not suitable for permanently wet places and for permanently elastic seals.
elastic seals. Use Bison Silicone sealant for this).

Area of application
Suitable for sealing low-acting joints, seams and cracks at
door and window frames, window sills, panelling, stairs, skirting boards, walls,
plasterboard, ceilings and transit pipes. Also suitable for sealing cracks
of cracks and fissures in walls. Adheres to brick, (gas) concrete, masonry,
plaster, wood and most other porous substrates. Does not adhere
bitumen, PE, PP, P.T.F.E. and silicones. For sealing in glazing use Bison
Glazing sealant. Not suitable for bitumen, silicones, polyethylene
(PE), polypropylene (PP) and P.T.F.E.

Properties
- Paintable
- Tight-fitting
- Easy to process
- Moisture-resistant
- Excellent adhesion without primer
- Very good sprayability
- UV- and weather-resistant
- Can be used indoors and outdoors
- Permanently elasto-plastic (max. 12.5% elongation)
- Temperature resistant from -20°C to +75°C

Preparation
Processing conditions: Only process at temperatures
between +5°C and +40°C.
Surface requirements: Surfaces must be thoroughly dry, clean and free of dust, rust and grease.
Preliminary treatment surfaces: For an attractive result, tape the edges of
the joint with masking tape. Ensure a minimum joint width of
6 mm. Up to 12 mm joint width, the joint depth should be 6 mm. For larger
joint widths, the joint depth is half the joint width. Remove masking tape immediately
after smoothing.
Tools: Use the cartridge with Power Pistol. Multi Tool for opening the cartridge and
of the cartridge and smoothing out the sealant.

Processing
Consumption: Contents suitable for approx. 8-15 metres (depending on joint diameter).
of the joint).
Instructions for use:
Process tube with sealant gun. Open the cartridge by cutting off the plastic nipple
cutting off the plastic nipple at the top with a sharp knife up to the thread. Screw the nozzle
and cut off at an angle at the desired opening. Ensure a
minimum joint width of 6 mm and maximum 24 mm. The depth of the
joint should be 6 to 9 mm. Spray sealant evenly into the joint and apply within 15
minutes with a moistened putty knife or Bison Multi Tool. Apply the
removed immediately after smoothing. After 1 hour a surface
a surface skin will form.
Stains/Residue: Remove wet stains immediately with water. Hardened
residues can only be removed mechanically.
Points of attention: The sealant is paintable after complete curing.

Only for manufacturing defects.

Right of return

You have a trial period of 14 days. If the product is not to your satisfaction, you can return it to us. The product can only be returned if the outer packaging (seal) is closed.