SUITABLE FOR:

• It repairs in a few seconds (about 30 sec depending on materials, humidity and temperature levels)
• all kinds of materials such as wood, metal, ceramic, stone, glass and plastic, both two same materials together and
• combinations thereof.

Processing conditions

Application temperature: between +5 °C and +25 °C.

Preliminary treatment surfaces

Surface must be dry, clean and free from dust and grease. Rub smooth surfaces with sandpaper (e.g. metal).

Instructions for use

• Remove the black cap on top of the syringe to mount the double syringe and insert the white plunger into the syringe.
• Turn the grey cap (90°) to open the syringe and attach the mixer.
• Press the plunger and remove the first drops of glue.
• Apply a thin layer of glue on one side. Press firmly for about 30 seconds.
• Once the repair is complete, remove the mixer and replace the grey cap to close the syringe so that the product can be used again.

Advice

• When doing multiple jobs, the product should be used about every 5 minutes to prevent curing in the mixer. If the product cures in the mixer, use a new mixer.
• Important: if you run out of mixers, it is possible to mix the product manually using a wooden mixing stick, keeping in mind that the adhesive may not be able to be mixed properly.

Stains/Residue

Remove wet stains immediately with warm water and soap. Cured adhesive residues can only be removed mechanically.

PROPERTIES

• -Superfast: approx. 30 sec
• -Ultrastrong
• -Filling capacity: unlimited
• -Yellowish consistency
• -Paintable and sandable
• -Temperature resistant: -40 °C / +80 °C
• -Water resistant
• -Without solvents
• -Precise and clean application
• -Transparent

Storage conditions

Store in a dry, cool place.