Data

Information

Product description
Refractory sealant for repairs and seals on fireplaces
stoves and chimneys. Also suitable for mounting and sealing of
concrete fireplaces and barbecues. Heat-resistant up to 1250°C.

Area of application
Suitable for repairing and sealing cracks, seams and joints
for fireplaces, all-purpose burners, stoves, chimneys and for fitting and sealing concrete hearths and
sealing of concrete fireplaces and barbecues. Also suitable for temporary
sealing of exhaust systems for cars and motorbikes. Adheres to metal
stone and concrete. Not suitable for central heating systems and gas pipes.

Properties
- Heat resistant up to 1250ºC
- Forms a tough seam
- For fire-resistant sealing

Preparation
Processing conditions: Process only at temperatures
between +5°C and +40°C.
Surface requirements: Surfaces must be thoroughly dry, clean and free of dust, rust and grease.
Preliminary treatment surfaces: Degrease metals with Bison Degreaser
or acetone. For application on porous surfaces, slightly moisten the surface with water.
slightly with water.
Tools: Use the tube with Power Pistol. Multi Tool for opening the tube and
the cartridge and smoothen the sealant.

Processing
Consumption: Contents suitable for approx. 8-15 metres (depending on joint diameter).
of the joint).
Instructions for use:
Process tube with sealant gun. Open the cartridge by cutting off the plastic nipple
cutting off the plastic nipple at the top with a sharp knife up to the thread. Screw the nozzle
and cut at an angle at the desired opening. Before application
Slightly moisten the joint with water. Spray the sealant evenly into the joint and
immediately with a wet putty knife. Allow to dry for at least 24 hours.
Then gently fire until the sealant has hardened. For exhaust systems, first apply a
apply a layer of sealant, immediately press a piece of glass fabric cloth into it and cover this
again with sealant. Allow to dry for at least 24 hours. Remove excess sealant
with water.
Stains/Residue: Remove wet stains immediately with water. Cured
residues can only be removed mechanically.
Points of attention: Heat exposure of the sealant when it is not yet fully
may result in cracking and even crumbling of the sealant.
After some time a liquid layer will appear on the sealant, however this has
has no effect on the quality of the sealant. Application on electrical equipment can be
hazardous due to the conductivity of the product.

Only for manufacturing defects.

Right of return

You have a trial period of 14 days. If the product is not to your satisfaction, you can return it to us. The product can only be returned if the outer packaging (seal) is closed.