Product description
Super strong, fast gel-type instant glue that is correctable and lightly filling.
Ideal for porous materials.

Field of application
Glues various materials such as pottery, porcelain, cork, wood, cardboard, metal,
rubber and many plastics. Not suitable for some plastics (PE, PP,
P.T.F.E. and silicone rubber) and car windows.

Properties
- Does not drip or run off vertical surfaces
- Can be corrected in a short time
- Light filling (thus also for less well-fitting parts)
- Ideal for porous materials
- Super strong
- Fast

Preparation
Processing conditions: Do not process at temperatures below
+10°C.
Surface requirements: The materials to be bonded must be thoroughly clean, dry,
dust- and grease-free and well-fitting.
Pre-treatment surfaces: Degrease with acetone or Bison Degreaser.
Acid reacting surfaces (such as aluminium) must first be treated with diluted
ammonia and then rinse with water and dry.
Lightly sand metals.
Tools: Can be applied directly from the tube using the fine dispensing tip.

Processing
Consumption: One drop is enough for approx. 2 cm². Only for spot bonding.
Directions for use:
Apply the adhesive as thinly as possible (less than one drop) to one of the parts to be glued
parts to be bonded (too much glue greatly delays curing!). The nozzle must
touch the surface. Apply the parts directly to each other and for
short time (10-60 sec.) so that the glue spreads evenly over the surfaces.
surfaces. Hand pressure is sufficient. When bonding metal, the
curing time can be shortened by briefly breathing on the bonded part before putting it together.
the part being glued in. After use, clean the nozzle of the tube immediately with a dry cloth.
dry cloth and close the tube by turning back the black cap.
twist back the black cap. Expose the glue to air as briefly as possible.
Points of attention: Caution: Second glue contains cyanoacrylate. Hazardous:
Glues skin and eyelids together within seconds. Keep out of reach of
children. If contact with skin has occurred, avoid
forced attempts to remove the adhesive. In such cases, the adhesive will
be repelled by the skin by itself. Then wash the skin with water.
If the adhesive has got into the eyes, keep the eyelids open, rinse immediately with
water and call a doctor. Separate sticky fingers by
soaking well in water and then rolling between them with a pencil.

Drying times*
Hand-holding time: approx. 15 seconds to 2 minutes, depending on the nature of
the materials to be bonded. After 2 to 10 minutes, the adhesion is sufficient for
practical use.
Final strength after: approx. 24 hours.
* Drying times may vary depending on, among other things, substrate, applied quantity of product,
moisture content and ambient temperature.

Storage conditions
Minimum 24 months after production. Opened packaging has a limited
shelf life. Store in a dry, cool and frost-free place. Maximum
shelf life is achieved by storage below +5°C (in the refrigerator).