Data
| Brand: | Bison |
| Model: | sealant transparent |
| Moisture resistance: | Good |
| Viscosity: | approx. Liquid |
| Solids content: | approx. 21% |
| Colour: | Transparent |
| Content: | 100ml |
| Delivery: | 1 tube |
Information
Product description
Super strong, crystal-clear universal contact adhesive based on polyurethane rubber, synthetic resins and solvents.
Field of application
Extremely suitable for bonding many transparent materials such as plexiglass, perspex, polycarbonate. Also glues (imitation) leather, vinyl, soft PVC
cork, canvas, textiles and many hard and soft plastics such as PVC, ABS and polystyrene. Very suitable for repairing e.g. shoes, bags, toys, book covers, nameplates or when making (hobby) handicrafts. Extremely suitable for gluing PVC pond liner. Not suitable for polystyrene foam (Tempex®, Styrofoam), polyethylene (PE) and polypropylene (PP).
Properties
- Crystal-clear
- Instantly adherent
- Super strong
- Does not discolour
- Suitable for materials under load
- Universal
- Moisture and frost resistant
- Easy to process
Preparation
Processing conditions: Process adhesive and parts to be bonded at room temperature. Relative humidity should be lower than 65%. This is to prevent blistering of the end result. After bonding, correction is no longer possible. Always test first on an (inconspicuous) part of the substrate.
requirements surfaces: Surfaces must be dry, clean, dust-, grease-free and properly fitted. Clean and degrease the surfaces to be bonded for optimum results.
Pretreatment surfaces: For optimum results, degrease first.
Tools: Solid brush or fine-toothed (1 mm) glue comb for spreading large surfaces. Pressure roller or rubber hammer for firmly joining the materials.
Processing
Consumption: 2-2.5 m2/litre, applied on both sides, depending on the nature of the materials to be bonded.
Instructions for use:
Stir well before use. Preferably do not dilute Apply adhesive thinly and evenly to both surfaces using fine-toothed notched trowel (1 mm) or brush. Allow both parts to dry for 10 to 25 minutes. As soon as the adhesive no longer pulls threads together. No further correction is possible. Avoid inclusion of air bubbles. Firmly tap, roll or press the materials.
Stains/Residue: Remove wet adhesive residues immediately with Degreaser/Thinner for Bison Kit®. Dried adhesive residues can only be removed mechanically or with a paint stripper (test beforehand).
points of attention: For optimal results, both the adhesive and the parts to be bonded must be at room temperature (certainly do not process below +10°C). The final strength of the bond depends on the applied pressure. Therefore, apply as much pressure as possible over the entire surface. If the adhesive bond with porous materials comes into prolonged contact with water, the adhesive may separate from the wet substrate.
Storage conditions
At least 24 months after production. Opened packaging has a limited
shelf life. Store tightly closed in a dry, cool and frost-free place.
Warranty
Only for manufacturing defects.
Right of return
You have a trial period of 14 days. If the product is not to your satisfaction, you can return it to us. The product can only be returned if the outer packaging (seal) is closed.
