Data

Information

Product description
High-quality, permanently elastic and water-resistant silicone sealant on a
acetic acid-based silicone sealant for sanitary seals. Mould resistant. After 2 hours
chargeable with water.

Area of application
Suitable for sealing joints, seams and cracks in bathrooms
kitchens, toilets and showers. Specifically for seals in sanitary and
ceramic applications such as joints between wall tiles, bathtubs
shower cubicles, washbasins, countertops, sinks and between tiled walls.
Adheres to plain glass, ceramics, glazed tiles, enamel, metals, wood and
various plastics. No adhesion to bitumen, polyethylene, polypropylene
and P.T.F.E. For acrylic baths, shower trays and plastic shower walls Bison
Silicone sealant for acrylic baths. Not suitable for aquariums, acrylic
bitumen, polyethylene (PE), polypropylene (PP) and P.T.F.E.

Properties
- Mould resistant
- Showers after 2 hours
- (Sea) water resistant
- Excellent adhesion without primer
- Chemical-resistant
- Colourfast
- Permanently elastic
- UV- and weather-resistant
- Temperature resistant from -30°C to +150°C
- Easy to process

Preparation
Processing conditions: Only process at temperatures
between +5°C and +40°C.
Surface requirements: The substrate must be thoroughly dry, clean and dust-,
rust, paint and grease free. Pre-treat plastics with Bison Silicon
Primer. Roughen plastics first.
Pre-treat surfaces: For an attractive result, apply painter's tape
along the edges of the joint. If necessary, prevent three-surface adhesion
by applying filler foam or PE foil in the joint.
Tools: Use the cartridge with Power Pistol. Multi Tool for opening the
of the cartridge and smoothing the sealant.

Processing
Consumption: Contents suitable for approx. 8-15 metres (depending on joint diameter).
of the joint).
Instructions for use:
Process tube with sealant gun. Open the cartridge by cutting off the plastic nipple
cutting off the plastic nipple at the top with a sharp knife up to the thread. Screw on the nozzle
and cut off at an angle at the desired opening. Ensure a minimum
joint width of 6 mm and a maximum of 20 mm. The joint depth depends on
the joint width. Up to 12 mm joint width, maintain a joint depth of 6
mm. Above that, the joint depth is half the joint width. Apply sealant evenly and
and smoothen with a mild soap solution within 10 minutes (using Bison Multi Tool).
(using Bison Multi Tool). Remove the applied masking tape immediately after smoothing.
remove. A surface skin will form after approx. 15 minutes. Cured
silicone sealant can only be removed mechanically.
Stains/Residue: Remove stains immediately with white spirit. Cured sealant can
only removable mechanically or with Bison Silicone sealant residue remover.
Points of attention: Silicone hardens under the influence of air humidity.
Therefore, during curing, contact with air humidity is essential.
is essential. Always allow for a joint at least 6 mm wide.
Use masking tape along the joints to achieve completely smooth seams.
Remove this tape immediately after smoothing. After 2 hours the sealant is
can be charged with water, but do not touch or mechanically charge.

Only for manufacturing defects.

Right of return

You have a trial period of 14 days. If the product is not to your satisfaction, you may return it to us. The product can only be returned if the outer packaging (seal) is closed.